The next step is the configuration of static default routes for both links. Otherwise, two nat rules will be created for both out interfaces. The reason I created the WAN interfece list was to simplify the NAT configuration. Choose WAN (the one created earlier) as your out interface list. After that, go to IP > firewall > NAT and create a masquerade rule. The bridge port or whatever interface you are using for your LAN should be added to the LAN interface list. Next, create an interface list and add Ether1 and Ether2 to the WAN interface. 10.0.0.19/16 was statically assigned to Ether2 for connection to ISP2, and 192.168.88.1/24 was assigned to the LAN interface. The static address 192.168.11.4/24 is used for ISP1 on ether1. On my router, Ether1 is connected to ISP1 while Ether2 is connected to ISP2. Mikrotik automatic failover configuration Also, the system must be able to return control to the primary link immediately the failure is resolved. If you have a dual-ISP connection where one is preferred over the other, you need a system that will route all user traffics out of the primary link but with the ability to automatically switch control to the secondary whenever a failure is detected on the primary link.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |